CEC Product 3

ce_logo_finals2.gif (7429 bytes) FULL FLOODED LATENT HEAT STORAGE UNIT

Sales_brochure_Fcoil_with_drum.jpg (118042 bytes)

Sales_brochure_DF_Coil.jpg (160489 bytes)

SINGLE BANK FULL FLOODED MODEL

Single bank-full flooded units are available for latent heat storage systems up to 80,000 lb of ice capacity. The piping is fabricated into serpentine coil assemblies called circuits and are arranged in columns. These units incorporate the use of a surge drum conforming to A.S.M.E. standards. The surge drum is used to maintain separation of the gas and liquids within the coil assembly. Components used in the system include a float switch, liquid line with manual expansion valve, solenoid valve and strainer, shut off valve, dual pressure relief valve assembly and an optional large suction shut off valve. All components are shown in the photo.

DOUBLE BANK FULL FLOODED MODEL

Double bank-full flooded systems are available to 105,000 lb ice capacity. This equipment incorporates two separate single bank coil assemblies installed in one common tank. Each coil assembly is piped to one common surge tank and served by one common liquid leg. Dual coil assemblies are used to reduce the pressure loss and increase operating efficiency. As with all coil assemblies, each system is completely assembled, welded and tested in our shop prior to shipment.

GENERAL FEATURES

The tank is fabricated from 1/4" thick steel plate.

All tank seams are double welded inside and out and then tested for leaks.

  Tank bottom is constructed of double steel plate with insulation in between.

Heavy duty structural steel stiffeners are used for the tank walls, corners and top and bottom  perimeters to prevent tank distortion and to provide a rigid assembly.

The exterior structural steel and the tank interior are coated with zinc dust primer.

   Polystyrene insulation board is used on the exterior of the tank walls and floor, then covered with stucco embossed aluminum sheet metal which does not require painting.

  The tank exterior is furnished with jacking and lifting lugs for handling.

   The embossed aluminum top covers are formed in sloping sections and are designed for self draining.

The coils are constructed from Schedule 40 black iron pipe meeting ASME/ANSI B31.5 standards.

Air distribution pipes are located in between each serpentine coil circuit for even air agitation throughout the tank.

The surge tank is fabricated to ASME standards and National Board Certified.

A high efficiency, compact, low pressure blower is provided for air agitation.

An optional automatic liquid level control can be mounted in the tank. The level sensor is protected from the air agitated movement of the liquid. The relay is mounted in an waterproof enclosure.

Ice bank control senses ice based on conductivity, temperature or both.

All models are constructed from the finest materials and fabricated with pride in workmanship.

TO DIRECT EXPANSION LATENT HEAT STORAGE UNITS
TO PRODUCT PAGE